// Turns off the given LED with the specified color.
func TurnOff(color Color, position Position) {
if color == Amber {
utilities.WriteIntValue(findFilename(Green, position), "brightness", 0)
utilities.WriteIntValue(findFilename(Red, position), "brightness", 0)
} else {
utilities.WriteIntValue(findFilename(color, position), "brightness", 0)
}
}
// Runs the motor at the given port.
// The meaning of `speed` parameter depends on whether the regulation mode is turned on or off.
//
// When the regulation mode is off (by default) `speed` ranges from -100 to 100 and
// it's absolute value indicates the percent of motor's power usage. It can be roughly interpreted as
// a motor speed, but deepending on the environment, the actual speed of the motor
// may be lower than the target speed.
//
// When the regulation mode is on (has to be enabled by EnableRegulationMode function) the motor
// driver attempts to keep the motor speed at the `speed` value you've specified
// which ranges from about -1000 to 1000. The actual range depends on the type of the motor - see ev3dev docs.
//
// Negative values indicate reverse motion regardless of the regulation mode.
func (self Motor) Run(speed int16) {
regulationMode := utilities.ReadStringValue(self.folder, regulationModeFD)
switch regulationMode {
case "on":
utilities.WriteIntValue(self.folder, speedSetterFD, int64(speed))
utilities.WriteStringValue(self.folder, runFD, "run-forever")
case "off":
if speed > 100 || speed < -100 {
log.Fatal("The speed must be in range [-100, 100]")
}
utilities.WriteIntValue(self.folder, powerSetterFD, int64(speed))
utilities.WriteStringValue(self.folder, runFD, "run-forever")
}
}
// Set the position of the motor at the given port.
func (self Motor) InitializePosition(value int32) {
utilities.WriteIntValue(self.folder, positionFD, int64(value))
}
func (self Motor) Turn(command string, data int64) {
utilities.WriteIntValue(self.folder, powerSetterFD, 50)
utilities.WriteIntValue(self.folder, "position_sp", data)
utilities.WriteStringValue(self.folder, runFD, command)
}